→ Shake or stir Evercrete Waterproofing prior to use.
→ The concrete substrate should be sound, free from voids, cracks, oil, grease, curing agents or other contaminants.
→ It is preferable to pre-wet the cleaned surface first. (Optional)
→ Apply Evercrete Waterproofing liberally by low-pressure spray.
→ Apply a second coat at least 24 hours after the first coat.
→ On walls, apply Evercrete Waterproofing from the bottom up.
→ On floors, apply Evercrete Waterproofing so that the surface has a mirror wet look. Do not allow ponding.
→ If the floor or wall is to be covered with tiles, paint, etc., wait at least seven days before covering.
→ Evercrete Waterproofing is not meant to fill or seal visible cracks.
→ Do not apply to glass, glazed surfaces, or aluminum as etching will occur. In case of accidental contact, immediately rinse thoroughly with water.